Super Smash Bros. Dual Poster Frame 3D Printer Model
The file 'Super Smash Bros. Dual Poster Frame 3D Printer Model' is (stl) file type, size is 15.5KB.
The file 'Super Smash Bros. Dual Poster Frame 3D Printer Model' is (stl) file type, size is 15.5KB.
note: new and improved frame can be found here: https://www.thingiverse.com/thing:6772756
This is a fun little frame I made for these posters I got for free at the Nintendo Store in Tokyo! Both the front and back were really cool, so I made this frame to showcase two of them to see both sides. To make the poster, I literally just glued the frame to a cardboard backing and used it to pin the poster in. The symbol itself is small, so a raft or brim is recommended. The individual frames’ STLs are named according to where they should go in the final project, but many of them are identical so mixing them around is ok. Be careful, though, as the pieces shaped like a “U” or an “L” are slightly different sizes–the left ones are a little bit longer than the ones on the right side. I also ran into an issue where the Symbol loaded into Bambu Studio 10x smaller than it should have been, so if it is less than a tenth of a millimeter thick, scale it up 10x. Showcase below.
https://youtube.com/shorts/1RUKhyjbThU?feature=share
| bottomleftbar.stl | 684.0B | |
| bottomleftcorner.stl | 1.4KB | |
| bottommiddlebar.stl | 684.0B | |
| bottomrightbar.stl | 684.0B | |
| bottomrightcorner.stl | 1.4KB | |
| middleleftbar.stl | 684.0B | |
| middlerightbar.stl | 684.0B | |
| middlesymbol.stl | 8.5KB | |
| signbottomleft.stl | 14.1KB | |
| signbottomright.stl | 11.6KB | |
| signupperleft.stl | 9.8KB | |
| signupperright.stl | 13.0KB | |
| topleftbar.stl | 684.0B | |
| topleftcorner.stl | 1.1KB | |
| topmiddlebar.stl | 684.0B | |
| toprightbar.stl | 684.0B | |
| toprightcorner.stl | 1.1KB |
