This is a super tight bearing for testing printer settings!!! Extremely dense bearing!!!
I printed it out and it works! The camp is spinning!
But you must have a very well set up printer! Layer height not more than 0.14 mm. !!!
Some slicers do not dare to cut the object properly and glue the moving parts! Carefully inspect layer by layer whether the slicer has prepared the object correctly !!!
I guarantee it works and has been tested, but it is very difficult to smooth it properly and print it well. You may have to move the balls with a little force at first!
This is not a toy model. This model is realy for 3D printer testing! For most people will be dificult to slice and print it...
All the models I upload are free to use! But despite everything, you can thank me if you want by treating me to a beer or a coffee with juice :))
The time I spend creating, drawing, actually testing the models and correcting them sometimes takes an awful lot of my working and personal time...
Here is my personal bank account-
SWIFT: STSABGSF
BG11STSA93000018780159
With respect...
| Assembly_lager_v2.STL | 3.5MB | |
| Bearing.STEP | 118.1KB | |
| bearing_for_test_v2.STL | 21.4MB | |
| lagr_s_luft.STL | 2.3MB |
