Tightened up the tolerances for a better fit (0.1mm for all parts except the face (0.175mm)).
Added a hole for a 3mm³ magnet.
2 versions supplied; one that's double sided (no_base) and one with a printable base (.4mm). I used the one with the base so I could get the printbed texture on both sides.
Slightly bigger than the original and thicker too.
For the keychain print;
Outline_keychain_no_base
White_keychain
Colour_no_base
For magnet (with base) print;
Base
Outline
White
Colour
For magnet (without base) print;
Outline_no_base
White_no_base
Colour_no_base
| Base.stl | 7.1KB | |
| Colour.stl | 8.5KB | |
| Colour_no_base.stl | 8.5KB | |
| Outline.stl | 15.1KB | |
| Outline_keychain_no_base.stl | 16.9KB | |
| Outline_no_base.stl | 15.1KB | |
| White.stl | 13.0KB | |
| White_keychain.stl | 12.2KB | |
| White_no_base.stl | 13.0KB |
