The file 'SUP Lamp 3D Printer Model' is (stl,step) file type, size is 1.8MB.
This is a lamp based on the design of a real SUP-board.
If you only want to have the board itself you need to print SUP, SUP_Fin and SUP_Plug.
If you want to use it as a lamp you need everything but the plug used to seal the end.
Note the height of approximate 33cm, which is too much for most small printers.
I used M3x6mm screws to screw in the bottom plate und used a cheap 5V LED-stripe to illuminate the board from below.
Look at https://www.thingiverse.com/thing:2965219 for a paddle.
Check out https://www.thingiverse.com/thing:2860317 for a small keychain version.
Feel free to ask for further informations should any questions arise.
| SUP.stl | 545.9KB | |
| SUP_Cover.stl | 394.7KB | |
| SUP_Fin.stl | 17.5KB | |
| SUP_Lamp_v101.step | 3.9MB | |
| SUP_Plug.stl | 621.8KB | |
| SUP_Stand.stl | 467.2KB |
