This is a PLA plant container with wooden legs. I turned my own legs from Walnut, but you could use 3/8" dowels.
I have not tried printing the legs, but I did include an STL. If you do try printing the legs I would make sure to have horizontal expansion dialed in first. The models I have do not allow for any clearance between the legs and the shell so you will need to adjust accordingly.
UPDATE: I added the wide mouth version. The legs on this one are PLA also. They are a snug fit into the vase, so make certain you are printing accurately in X/Y. I printed both the vase and the legs with no support or bed adhesion. I did set my seam point in Cura to the center(ish) of the three legs so that it would be on the inside.
| Planter_Leg.stl |
| Planter_Legs_Wide.stl |
| Planter_Shell.stl |
| Planter_Shell_Wide.stl |
