Subwoofer Ring Extansion Mount 3D Printer Model
The file 'Subwoofer Ring Extansion Mount 3D Printer Model' is (stl) file type, size is 7.3KB.
The file 'Subwoofer Ring Extansion Mount 3D Printer Model' is (stl) file type, size is 7.3KB.
I´ve replaced a 40+ year old 200mm speaker on a selfmade PA-Speaker. However the cutout was oval and not round. Therefore only 2 holes covered the wood underneath it, while the other 2 original screws where drilled in a pice of cardboard, as a mount extansion.
So I created an extansion to propaply mount the speaker. The inner diameter is 184mm and the outer one is 236 mm. The holes for the speaker are at a diameter of 197mm and the new ones are at 225mm. I used a 3,5 - 4mm screw to attach the extansion to the speaker.
Since my printer is not so big and i wanted to safe some time, i did not print a whole ring. Also, I only needed 2 extansions for one speaker.
I hope this idea can help someone with a similar proplem or give the idea to crating extansions for diffrent speaker sizes.
| Subwoofer_Ring_Extension.stl | 37.7KB |
