Stool Foot
###########################################################################################
Some time ago I purchased a bar stool on eBay, with two broken feet.
The stool is otherwise of good design, fashioned as it is, in inch outside diameter light steel tubing.
The feet that I've designed for the stool are far tougher replacements than the original fittings, particularly when printed at a relatively high infill with PLA.
Though the feet were designed as stool feet, they would make equally good end stops for any tube structure, when the model is scaled appropriately for the application.
The print density should be varied to the usage...
###########################################################################################
Printer:
JGAurora A5
Rafts:
No
Supports:
Yea
Resolution:
0.2mm
Infill:
80% 3 Shells
Filament: Regular PLA Black
Notes:
Rafts optional.
Keep same orientation for print strength.
3D Printer: JGAurora A5
OS: 64-bit Linux Mint 20.3 (XFCE/xfce) “Ulyana” 64-bit
Software: FreeCAD Version 0.19.; ideaMaker Ver. 4.2.3.5600
Locale: English/United Kingdom (en_GB)
FreeCAD Version 0.19. was used to create all of the designs...
| Stool_Foot.stl | 861.0KB | |
| Stool_Foot.txt | 1.2KB |
