Stereo Mixer Clip Channel Joiner For Zoom LiveTrak L-20 L20 3D Printer Model
The file 'Stereo Mixer Clip Channel Joiner For Zoom LiveTrak L-20 L20 3D Printer Model' is (stl) file type, size is 8.1KB.
The file 'Stereo Mixer Clip Channel Joiner For Zoom LiveTrak L-20 L20 3D Printer Model' is (stl) file type, size is 8.1KB.
This consumable clip fits over two channels of the Zoom L-20 (and likely other) mixers, so that you can move 2 faders at the same time. It is very small and thin by design - if your printer has a hard time with that, your best bet may be to print half a dozen at a time so that you can discard the bad ones.
To install:
Remove fader caps from 2 adjacent mixer channels
Move sliders all of the way to the top
Snap clip over both faders and slide to the back
Replace fader caps
Success!
| HiveMindMixerClipZoomLiveTrakL20.stl | 30.9KB |
