Stepper Mount For Fan And Heatsink 3D Printer Model
The file 'Stepper Mount For Fan And Heatsink 3D Printer Model' is (STL,txt) file type, size is 30.9KB.
The file 'Stepper Mount For Fan And Heatsink 3D Printer Model' is (STL,txt) file type, size is 30.9KB.
Mount for a fan (40x40x10) and a heatsink (40x40x11) to be used in Nema17 stepper motors. Snaps well in place.
Preferable to use thermal paste between heatsink and stepper in order to achieve better heat transfer.
Use high-temp plastics such as PETG or ABS. The part will be in direct contact with the stepper, so PLA will soften easily. I used ABS. No Supports required.
Needed to hold the fan to the mount: 3mm Nuts(x4), M3x15mm Screws (x4)
Any question: feel free to comment down below.
v2.: The fit for the heatsink was too tight, causing the arms to bend a little bit, which caused the whole mount to be somewhat loose. Problem fixed!
| E_Mount.STL | 622.5KB | |
| ReadMe.txt | 223.0B |
