Steckspiel Mit Dübel 3D Printer Model

License: CC BY-SA
File formats: dxf,stl
Download type: zip
Size:595.6KB

The file 'Steckspiel Mit Dübel 3D Printer Model' is (dxf,stl) file type, size is 595.6KB.

Summary

Altes Kinderspiel als Reisespiel (Neuauflage)

Druckanweisungen:

Das Spiel besteht aus zwei Teilen:

  • Boden: Muss separat in 100% Größe ohne Support gedruckt werden. Ein Brim kann optional verwendet werden.
  • Deckel: WICHTIG: Der Deckel muss in 98% Größe gedruckt werden, da das Gewinde sonst zu straff sitzt.

Zusätzlich benötigst du einen Würfel sowie ca. 12 kurze Holzdübel (6mm Durchmesser).

Spielanleitung:

  1. Jeder Spieler erhält die Hälfte der Dübel.
  2. Der erste Spieler würfelt und steckt einen Dübel in das Loch, das der gewürfelten Augenzahl entspricht. Das durchgehende Loch in der Mitte entspricht der Zahl 6.
  3. Befindet sich bereits ein Dübel im gewählten Loch, entnimmt der Spieler diesen und legt ihn auf seinen Stapel.
  4. Der Spieler, der zuerst keine Dübel mehr hat, gewinnt.

Classic Children’s Game as Travel Edition (Remake)

Printing Instructions:

The game consists of two parts:

  • Base: Print the base separately at 100% size, without support. A brim can be used if needed.
  • Lid: IMPORTANT: The lid must be printed at 98% size, otherwise the thread will be too tight.

You will also need a die and about 12 short wooden dowels (6mm diameter).

Game Instructions:

  1. Each player receives half of the dowels.
  2. The first player rolls the die and inserts a dowel into the hole corresponding to the rolled number. The through-hole in the middle corresponds to the number 6.
  3. If there is already a dowel in the chosen hole, the player removes it and adds it to their pile.
  4. The player who runs out of dowels first wins.
Anleitung.dxf 1.5MB
Boden.stl 230.4KB
Deckel_V16-Dübel_6mm_1.stl 838.3KB