FULL DISCLOSURE: I have not flown this yet
Printed files to be combined with 2 lengths of BT-80 model rocket tube (66mm)
Superheavy BT-80 : 42.5cm (Fincan V2)
Starship BT-80: 10.5cm
Starship BT-80 Mk3: 10cm
2x Utility Tunnel covers should be printed and these are made a little long so they can be trimmed to match the BT-80 tube length for starship
You will need other internal tubes and centering rings depending on the motor chosen and will have to devise a recovery method.
I have used these super cheap chutes in previous rockets: https://www.youtube.com/watch?v=CISZ7RUye5w
This model is fairly simple and the heat-shield side profile for starship is off so I'll mark this a work in progress. The designs are fluid anyway at this point but some nice chrome and black paint and this should look pretty good to be getting by with.
Credit for inspiration to: https://www.thingiverse.com/thing:3192548
There are some good examples of internal design in the makes there.
NOTICE: If you downloaded the version one fincan your tube length is as follows:
Superheavy BT-80 : 45cm
| Starship_Bottom.stl | 769.0KB | |
| Starship_Mk3_Nose.stl | 3.5MB | |
| Starship_Mk3_Tail.stl | 485.9KB | |
| Starship_Mk3_Tail_with_Camera.stl | 464.4KB | |
| Starship_Nose.stl | 1.0MB | |
| Starship_Utility_Tunnel_Cover.stl | 3.4KB | |
| Super-Heavy_Fincan.stl | 165.4KB | |
| Super-Heavy_Fincan_V2.stl | 204.8KB | |
| Super-Heavy_Fincan_V2_Estes_3090_Compatable.stl | 202.9KB |
