Starship LED Glow In The Dark Lamp 3D Printer Model
The file 'Starship LED Glow In The Dark Lamp 3D Printer Model' is (stl,3mf) file type, size is 130.6MB.
The file 'Starship LED Glow In The Dark Lamp 3D Printer Model' is (stl,3mf) file type, size is 130.6MB.
Starship LED glow in the dark lamp. Is a replica from the reservoir and tube disposition of SN8 and mix with one of the renders of the future starship. Reason to not update to the new reservoir disposition is that looks cooler this way
Dimensions:
Height: 52cm - divided in 3 sections so it can be printed in almost any printer
Diameter: 9 cm not including the extra length of the canards.
LEDs can be installed on the inner tube and a back access panel has been added to allow operation of the LED controller.
There are spot faces for 5mm magnets but i don't use them since the fit is very good and does not require it
Please in case you want to use it for commercial purposes contact me.
| bottom_inner_tube_-_no_support-_any_pla.stl | 2.6MB | |
| bottom_shiedls-_support_-_black_pla.stl | 35.2MB | |
| bottom_tube_-_supports_-_glow_in_dark_-full_infill.stl | 3.4MB | |
| controller_cover_-_no_support-_black_pla.stl | 1.1MB | |
| full-do_not_print.stl | 102.2MB | |
| full_print.3mf | 25.9MB | |
| Left_bottom_canard-_no_supports_-glow_in_dark_-_do_simmetry.stl | 611.9KB | |
| Left_bottom_canard_cover-_supports_-black_pla__-_do_simmetry.stl | 3.1MB | |
| Legs-_no_support-_silver_pla.stl | 1.6MB | |
| mid_inner_tube_-supports_-any_pla.stl | 498.7KB | |
| mid_shields_-_supports_-black_pla.stl | 19.1MB | |
| mid_tube-support-glow_in_dark-full_infill.stl | 1.9MB | |
| top_inner_tube_-_support-_any_pla.stl | 2.8MB | |
| Top_left_canard_-_no_support-glow_in_dak_-_do_simmetry.stl | 797.7KB | |
| Top_left_canard_cover_-_support-black_pla_-_do_simmetry.stl | 4.7MB | |
| top_shields_-supports-_black_pla.stl | 16.1MB | |
| top_tube-supports-_glow_in_dar-full_infill.stl | 2.3MB |
