Starlink Cable Wall Pass Through 3D Printer Model
The file 'Starlink Cable Wall Pass Through 3D Printer Model' is (STL) file type, size is 443.8KB.
The file 'Starlink Cable Wall Pass Through 3D Printer Model' is (STL) file type, size is 443.8KB.
This is an exterior wall pass through for the Starlink Dishy cable. You will need to drill a hole into the wall with a 1" spade or hog bit, then caulk the tube into place to prevent water intrusion. The pass through cap has a water shield on the top and sides, with a bottom wire egress so the cap will not need to be caulked. This allows for easy removal of the cap to reposition Dishy or remove the cable. After permanently locating the dish, I would finish caulking the wire egress to prevent moisture or insects.
The cable choke should be a slip fit through the tube. If you're having trouble with the choke not fitting, scale the model by a few percent. There are different tube lengths and angles to work with different siding and wall thicknesses. The 3 inch tube 10 deg will work with most vinyl siding and pass through the exterior sheeting. Use the 7inch tube if you need to pass all the way through interior sheetrock.
Edit:// Added caps for use with 3/4" and 1" Sch40 PVC pipe. Note that the diameters are "sold" diameter not actual. A 3/4" PVC pipe has an O.D. of 1.050". A 1" PVC pipe has an O.D. of 1.315".
| Pass_Through_Cap.STL | 178.7KB | |
| Wall_Cap_0.75inch_Sch40_PVC_Pipe.STL | 202.1KB | |
| Wall_Cap_1inch_Sch40_PVC_Pipe.STL | 204.6KB | |
| Wall_Tube_3_inch.STL | 108.9KB | |
| Wall_Tube_3_inch_10deg_.STL | 169.9KB | |
| Wall_Tube_5_inch.STL | 95.8KB | |
| Wall_Tube_5_inch_10_deg.STL | 153.4KB | |
| Wall_Tube_5_inch_15deg.STL | 153.1KB | |
| Wall_Tube_7_inch.STL | 86.8KB | |
| Wall_Tube_7_inch_10_deg.STL | 141.6KB |
