This is a card deck box that will hold up to 200 sleeved smaller cards (39mm x 63mm)
The print comes with 2 card separators because that is what fit on my printer.
There is a slot on the sides of the bottom piece, and tabs on the top so it clicks into place and stays in place. You can turn it upsides down with cards in it and it will hold in place.
Finger holds are put on the side of the box to make it easier to grasp and open.
Four small holes are in the top of the box lid to allow air to escape, or enter while you open and close it for easier use.
I did not add any fancy names or logos to the top but that could easily be added as well.
UPDATE: I have added a file for just the card separators.
| X_Wing_Card_Box.stl | 212.6KB | |
| X_Wing_Card_Box_2_Inserts.stl | 10.8KB | |
| X_Wing_Card_Box_85mm_120mm.stl | 202.9KB | |
| X_Wing_Card_Box_Inserts.stl | 19.5KB |
