Star Wars Themed Light Up Pencil Holder 3D Printer Model
The file 'Star Wars Themed Light Up Pencil Holder 3D Printer Model' is (stl) file type, size is 363.8KB.
The file 'Star Wars Themed Light Up Pencil Holder 3D Printer Model' is (stl) file type, size is 363.8KB.
Here is a pencil holder that is star wars themed. It has the star wars logo on one side, the Jedi logo, the sith logo, and the rebels logo. There are little holes on the lower rim of each face which can house 2 LEDs per face. There is also an electronics housing which attaches to the bottom of the pencil holder. The led holes lead to the little slots on the electronics housing so that you can run wires and the electronics housing can hold your wires and resistors and batteries. Comment down below if u have any questions or concerns.
| Assembly1.stl | 831.1KB | |
| base_plate.stl | 684.0B | |
| electronics.stl | 140.8KB | |
| jedi_face_3.stl | 175.4KB | |
| rebel_face_4.stl | 217.4KB | |
| sith_face_2.stl | 108.1KB | |
| starwars_face_1.stl | 153.0KB |
