A large scale star destroyer printable on small print areas. work in progress. model approx.525 mm long after assembly. Printed in PLA. I use DAP rapid fuse glue for assembly.
All detail pieces need to be scaled.
Cannons need to be scaled.
With a length of 1,600 meters, the wedge-shaped Imperial I-class Star Destroyer was 445 meters longer than its immediate predecessor, the Venator-class Star Destroyer, which had been developed for the Galactic Republic during the Clone Wars. In keeping with the Empire's habit of favoring muted colors whenever possible, the hull of the Imperial-class was painted in gray, while the Venator-class of the Clone Wars-era had red markings denoting the Republic's diplomatic immunity.
| bridge_face_half_left.stl | 2.5MB | |
| bridge_face_half_right.stl | 2.5MB | |
| plate.stl | 919.4KB | |
| round_plate.STL | 352.3KB | |
| shield_generator_part_2.stl | 47.9KB | |
| shield_generator_scaled.stl | 121.5KB | |
| stand_front.stl | 5.4KB | |
| Stand_rear.stl | 8.7KB | |
| star_destroyer_bridge_front.stl | 2.3KB | |
| star_destroyer_bridge_rear.stl | 22.2KB | |
| star_destroyer_cannon_scaled.stl | 147.5KB | |
| star_destroyer_center_section_left.stl | 69.0KB | |
| star_destroyer_center_section_right.stl | 73.1KB | |
| star_destroyer_center_thrusters.stl | 119.0KB | |
| star_destroyer_center_thusters_part_2.stl | 81.7KB | |
| star_destroyer_details.stl | 199.0KB | |
| star_destroyer_details_1.stl | 326.2KB | |
| star_destroyer_details_2.stl | 326.2KB | |
| star_destroyer_details_3.stl | 1.0MB | |
| star_destroyer_front_section__1_left__right.stl | 19.4KB | |
| star_destroyer_front_section__2_left__right.stl | 16.8KB | |
| star_destroyer_rear_section_part_1_left.stl | 56.3KB | |
| star_destroyer_rear_section_part_1_right.stl | 56.3KB | |
| star_destroyer_rear_section_part_2_left.stl | 23.0KB | |
| star_destroyer_rear_section_part_2_right.stl | 23.0KB |
