Star Wars Coins – Modular Insert Design 3D Printer Model
The file 'Star Wars Coins – Modular Insert Design 3D Printer Model' is (stl) file type, size is 94.5KB.
The file 'Star Wars Coins – Modular Insert Design 3D Printer Model' is (stl) file type, size is 94.5KB.
The dark side and the light side are just two sides of the same coin, right? At least they are in this case.
This is a simple modular coin design that consists of 3 parts: 1 rim and 2 inserts. I have included a blank for remixing or gluing your own designs to the coins as needed. The finished coins have a 36mm diameter and are 4mm thick.
The inserts are just the right size to snap into the rim and stay in place. When installed, the inserts have a little bit of play. This was to allow for various printer capabilities. If you don't like the bit of wiggle room that is left, you can put a small piece (or two) of standard office paper in between the inserts to get rid of the movement.
| Alliance_Insert.stl | 95.0KB | |
| Blank_Insert.stl | 26.3KB | |
| Coin_Rim.stl | 105.6KB | |
| Empire_Insert.stl | 102.4KB | |
| New_Order_Insert.stl | 66.1KB |
