Stand For Magic Keyboard / Magic Trackpad (1 Location) 3D Printer Model
The file 'Stand For Magic Keyboard / Magic Trackpad (1 Location) 3D Printer Model' is (stl) file type, size is 78.4KB.
The file 'Stand For Magic Keyboard / Magic Trackpad (1 Location) 3D Printer Model' is (stl) file type, size is 78.4KB.
I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work.
So I created my own support and I hope you like my work
I would be delighted if you took pictures of the impression of my work.
I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%
For the layer height I advise you to make 0.15mm but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not
You can find other version with two locations here
07/06/2020
09/06/2020
| Stand_Magic_Keyboard_1_Location-_Without_any_edge_v1.stl | 50.7KB | |
| Stand_Magic_Keyboard_1_Location_-_no_wall_edge_rounds_-_10mm_v1.stl | 69.4KB | |
| Stand_Magic_Keyboard_1_Location_-_no_wall_edge_rounds__-_5_mm_v1.stl | 64.7KB | |
| Stand_Magic_Keyboard_1_Location_10mm_v1.stl | 90.3KB | |
| Stand_Magic_Keyboard_1_Location_5mm_v1.stl | 85.6KB |
