This is a special stand for the 6" action figure of L337 as she has no holes in their feet for the normal stands and she stands not very stable

Attention: Action figures not included! ;-)

I made several different Star-Wars themed plate designs. As promised in my other baseplate thing (Find 6 baseolates here: https://www.thingiverse.com/thing:4802412 ) I made new ones after I got 100 likes, here they are:

https://www.thingiverse.com/thing:4865033

For each part there is a inlay which can be printed in a different color, or you can paint the baseplate.

The plate consists of the plate and the holder for L337 left leg, I added it 2 times if one of it is not printed right. You need only one, cut it away from the plate and click it in the plate.

After printing cut away the pins and the connector layer, and press the pins from the underside in the openings in the baseplate, they should fit in with a satiesfying click.

Tip: put them in place and place it on a flat hard surface and press from above on the plate till they click in.

It took me several optimizations till the pins had the right diameter for the little holes in the feet of the action figures and they clicked to the baseplate properly, but it still depends on the tolerances of your printer. So if the pins don´t hold properly use some glue or a soldering iron. If the Pins are too loose in the feet increase the size by 1 or 2 % (101% 102% upscaing in the slicer) or decrease the size if they don´t fit.

I Printed 20+ plates for all of my figures and they all worked fine.

Each plate takes approximately 1 hour to print at 0.2mm layers. Print without supports and without brim.

Legal stuff:
BY DOWNLOADING THE FILES FROM THINGIVERSE YOU AGREE TO THE FOLLOWING TERMS AND CONDITIONS:
The files are for private use only!
You are allowed to print parts from them for your personal use only!
You are not allowed to use this files or parts you printed with the use of this files of it in any comercial way!
If you are distributing Pictures from parts or models you build with theses files you are only allowed to to so if you are declaring the source of the design. You have to add a link to this thingiverse-thing in the description of your Fotos!
You are not allowed to copy or distribute them in any way!
You are not allowed to sell them or parts you printed from them or models you build with the use of this files!