I needed some stanchions for a small event, but as they are expensive, I decided to do a simple one with PVC pipe, concrete bases, and some 3D-printed toppers.

I have two options available for the toppers:

1. Print in two pieces and glue them together afterward
2. Print in one piece (longer print time because of support needed)

Both models need support, but the two-piece one needs significantly less. The bottom of the top piece curves up a little, so a little support is printed there.

Complete project:
Stanchion topper: 3D print
Stanchion pole: 1.5" PVC
Stanchion base: concrete (learned how to do this by looking up videos on making concrete bases for giant flowers)

Note: This is more for decoration than for any actual crowd control.