A simple stackable box that you can put pretty much anything into. I printed this one in Glitter PLA but any material will work.
I printed a simple tool to center the handle, place it over the lid, twist slightly to pull it tight and then place the handle in the center hole while gluing into place. I used 5 minute epoxy but be careful not to use too much, you can see in the photo I did use more than I needed to and the epoxy did squish out a little, nonetheless it still works just fine. The bottom brackets probably don't need to be glued onto the bottom of the boxes, they should fit nice and snug but use a drop or two if you like.
| Alignment.stl | 41.3KB | |
| Body_Holes.stl | 1.3MB | |
| Body_NoHoles.stl | 1.2MB | |
| Bottom_Bracket.stl | 50.9KB | |
| Handle.stl | 2.6MB | |
| Lid.stl | 8.5KB |
