A stack-able holder for tin foil, plastic wrap, cling wrap, etc.. that comes in 12 inch tubes. Designed in small parts that should be glued together in order to work with smaller print beds.
For stacking use the alternate bottom piece instead of the one for both top and bottom.
If you're making the bottom piece/ only one dispenser use 4 of the top and bottom walls. If you're making one that will stack on top of a bottom one then use 2 of the top and bottom walls and 2 of the bottom walls.
| back_wall.stl |
| back_wall_spacer.stl |
| bottom_walls.stl |
| front_door_part_1.stl |
| front_door_part_2.stl |
| roll_pin.stl |
| side_wall_left.stl |
| side_wall_right.stl |
| top_bottom_spacer_wall.stl |
| top_bottom_walls.stl |
