I have made a few parts for the Spyda 500. Body shell, Top plate with mounting points for the MultiWii/Cirrus controller board case that I have also included. The controller case mounts to the top plate with orange ear plugs to give vibration isolation.
I have also added a stronger DJI arm after finding that the included DJI one flexes quite a bit.
Added a mount that can be used for APM 2.5 with my top plate. Called generic mount.
Added a wall bracket to store your Spyda 500.
Added a gimbal mount that fits on the front and will bolt to top and bottom plate with 4 m3 socket head cap screws. The mounting holes are 2.5mm I tap them out to m3. you will need to make two holes in top and bottom plate 34mm apart at centres. If you use my top plate the holes are already there but the bottom plate will need them.
| DJI_Arm_Stronger_V2.STL | 1.9MB | |
| Generic_Mount.STL | 349.4KB | |
| multiwii_case.STL | 153.5KB | |
| Spyda_Body_3.STL | 1.8MB | |
| Spyda_Gimbal_Motor_Mount.STL | 1.1MB | |
| Spyda_Top_Solid.STL | 780.1KB | |
| Wall_Quad_Bracket.STL | 418.7KB |
