This is a PTFE tube guide for the sprite extruder. I use it to feed the filament to the sprite struder. I have two drying boxes and I can swap filaments quite easy with this.
It uses a M4 bolt with a t-nut to secure the support to the top (not don´t if this is really needed).
The ptfe couplers are m5, I made the hole bit enoght to allow me to fix the couples without the screw thread.
Supports are needed but shoud be blocked on the front (2 holes facing down).
Printed with 0.4 nozzle with 0.2 resolution using PETG, but PLA should be fine.
| guide_V3-Body.3mf | 1.0MB | |
| guide_V3-Body.stl | 2.1MB | |
| guide_V3.FCStd | 333.9KB |
