Springy Apple Cable Savers 3D Printer Model
The file 'Springy Apple Cable Savers 3D Printer Model' is (stl) file type, size is 14.2 MB.
The file 'Springy Apple Cable Savers 3D Printer Model' is (stl) file type, size is 14.2 MB.
The charging/connection cable for the new iPhone 6 / iPad Air is smaller than previous cables and is prone to breaking at the joint between the connector and cable through use. This is a solution to help prevent cables from breaking.
Unlike alternative methods available to counteract this problem the Springy Apple Cable Saver does not just transfer the flex / break point away from the cable / connector joint to another point further up the cable.
The Springy Apple Cable Connector all but stops movement in the cable / connector joint area and also controls the degree of curvature in the springy area. This stops kinking / tight curves that can weaken the cable over time. The springy area is 'springy' to make the cable spring back to near straight as much as possible... graduating / minimizing curvature that can result in it breaking.
Three .stl files have been provided. They include the device end only, the usb end only and both ends in one file.
This prints well on a Replicator 2 / 5th Generation Replicator but the spring and designed in internal support pin may prove challenging for some machines. PLA is recommended to make it really springy when 3 shells and a high percentage of infill is used.
Hopefully this proves beneficial to lots of Apple device owners...
Note: If you like this check out the rest of my practical and fun designs.
| apple_cable_savers.stl |
| device_end.stl |
| usb_end.stl |
