Spring (6.2mm Inner, 9mm Outer, 10mm Height, With Rings At Top And Bottom) 3D Printer Model
The file 'Spring (6.2mm Inner, 9mm Outer, 10mm Height, With Rings At Top And Bottom) 3D Printer Model' is (stl) file type, size is 354.7KB.
The file 'Spring (6.2mm Inner, 9mm Outer, 10mm Height, With Rings At Top And Bottom) 3D Printer Model' is (stl) file type, size is 354.7KB.
made this remix so it's smaller and has a top and bottom ring.
print it really slow (I printed 1500mm/sec) and quite cold (I did 185 instead of my usual 195-200 for PLA), or else you never build in height, it just droops. Also, make certain the layers are as thin as possible, or else the hangovers are going to be bigger the thicker the layer. I did .15mm and that was too much. go as small as your printer allows for something this small.
should scale up well, probably not down though, it's already quite small.
good luck.
PLEASE like it or collect Ir or I Made IT, whatever applies..
| spring_with_rings_at_top_and_bottom_6.2mm_inner_hole.stl | 2.7MB |
