A project developed for misting / gardening purposes and for it's low cost potential.
For printing, the following is required:
1x "SprinklerElectric-SHORT_TRIGGER_PULLEY_BASE.stl"
2x "SprinklerElectric-MOTOR_DRIVER.stl"
2x "SprinklerElectric-ROPE_TENSIONER.stl"
2x "SprinklerElectric-MOTOR_DRIVER_CONNECTION.stl"
1x "SprinklerElectric-ANGLE_CONNECTION.stl"
1x "SprinklerElectric-MOTOR_MOUNT001.stl"
2x "SprinklerElectric-ANGLE_PADDING.stl" at 11mm height
1x "SprinklerElectric-ANGLE_PADDING.stl" at 6mm height
The "SprinklerElectric-ANGLE_PADDING.stl" object height must be adjusted before printing.
For example, see here.
Other parts:
| SprinklerElectric-ANGLE_CONNECTION.stl | 152.0KB | |
| SprinklerElectric-ANGLE_PADDING.stl | 23.3KB | |
| SprinklerElectric-MOTOR_DRIVER.stl | 619.3KB | |
| SprinklerElectric-MOTOR_DRIVER_CONNECTION.stl | 101.3KB | |
| SprinklerElectric-MOTOR_MOUNT001.stl | 549.9KB | |
| SprinklerElectric-ROPE_TENSIONER.stl | 158.1KB | |
| SprinklerElectric-SHORT_TRIGGER_PULLEY_BASE.stl | 773.2KB |
