This is low-filament spool holder that does not use more than 25m of filament to print
It supports multiple bearings 626,608,625, and you need to print Shaft,Roller and Snap Rings according to your bearing size everything else is universal.
The roller is removable and carries the bearings within itself, which need to be carefully press-fitted into the roller.
Make sure to use washers to pervent cracking.
I put tape on the roller to minimize sound and improve cushioning
Make sure to lay flat side down of roller and some snap rings when preparing print.
| Hanger_1.stl | 602.3KB | |
| Hanger_2.stl | 602.3KB | |
| Roller_608.stl | 364.2KB | |
| Roller_625.stl | 349.9KB | |
| Roller_626.stl | 376.4KB | |
| Shaft_608.stl | 180.4KB | |
| Shaft_625.stl | 184.7KB | |
| Shaft_626.stl | 168.1KB | |
| Snap_Rings_608626.stl | 64.2KB | |
| Snap_Rings_625.stl | 59.8KB | |
| Washers_4x.stl | 77.5KB |
