Spooderbox

Small Animal Enclosure.

This design is no longer availble for a free download. Vent and Hatch still availble for replacing broken/lost parts.

If you wish to have this enclosure it can be purchased on
![Spoodyliscious shop]. Any other store that makes Spooderboxes other than Spoodyliscious shop is selling them without permission and license and should be reported.

Quite simple and modernistic animal enclosure, requres 3 glass panes (one extra optional), some silicone, and a small animal.

Needed Parts:

• 3 glass panes the size of 154x154 (+-1mm) and max thickness of 4mm (3.5 max recomended).

• Aquarium/Food grade silicone

• Optionally a 135x50mm glass pane.

Instruction:

• Print all parts. Depending if you want windowed hatch or windowless one print a proper version. When needed print with supports from buildplate only.

  • Print a Spooderbox vent with no top and bottom layers, dense infill, and 4+ walls. Infill structure will act as a vent holes, make sure they are small enought to not let your animal escape.

• Slide into a base and glue using a silicone 2 side glass panels. Slide front panel in but do not apply silicone there, its design to as as a entry point that you can slide in and out at will.

• Glue vent to a Spooderbox top using silicone or other glue.

• Use silicone to glue Spooderbox top to a base, remember to not glue fron glass panel to anything and make sure you can slide it in/out.

• Optionally glue smaller glass pane to a hatch, or use windowless hatch.

• When all silicone sets fill enclosure with decour of your choice, and let your animal in, slide front panel in and close everything using top hatch.

Cubone skull I used as a decour can be found here: https://www.thingiverse.com/thing:2839481

I sized it down to around 5 cm.