This is a sink caddy with sections to hold a steel wool, rectangular sponge, food scraper, and two cylindrical brushes (large and small).
It includes drain holes to prevent water from pooling in the bottom.
There is a separate drainage tray that allows water to drain into the sink. Note that this is sized specifically for my sink/counter, so the front lip is nearly flush with the edge of the sink. If you have more or less space, this won't work, but you should be able to scale in X and/or Y directions to make it fit your kitchen. Keep in mind that if you scale too much, then the sponge, scraper, etc, will not fit.
I recommend printing the drainage tray in an orientation where the angled "floor" is horizontal when printed. This will give a true sloped surface instead of a stepped surface. Also, you might want to paint or otherwise seal the top of the drainage tray to ensure that water runs along the tray instead of seeping through it.
Enjoy!
Leave a tip (if you want) if you use this design.
| sink_caddy_drainage_tray.stl | 36.7KB | |
| sponge_holder_sink_caddy_v1.stl | 236.7KB |
