Spirited Away Bath Tokens And Mobile 3D Printer Model
The file 'Spirited Away Bath Tokens And Mobile 3D Printer Model' is (stl) file type, size is 260.8KB.
The file 'Spirited Away Bath Tokens And Mobile 3D Printer Model' is (stl) file type, size is 260.8KB.
I modeled this mobile based on the movie Spirited Away.
The ten different tokens are 15 x 5 x 0,5 cm (length x width x height, conversion to imperial below).
There are three rings that I've modeled. I wanted to use the small (Ø15 cm) and the large (Ø22 cm) one, but the large one was too big for my printer, so I modeled a medium one (Ø20 cm).
You can install 7 tokens on the large/medium rings and 3 tokens on the small ring. There are three small holes in each ring to hang up the mobile (I used a clear nylon thread).
I printed the tokens with a white filament and painted them by hand. The rings are printed with a marbled filament, but you can use whatever filament you like.
The purple ribbon I used to connect the tokens to the rings is 2,5 cm wide. I chose the purple colour because of references from the movie (visit the Ghibli Wiki for screenshots, references, etc.).
Conversion of the dimensions
0,5 cm = 0.2″
2,5 cm = 1″
5 cm = 2″
15 cm = 5.9″
20 cm = 7.9″
22 cm = 8.7″
| Mobile_large.stl | 300.7KB | |
| Mobile_medium.stl | 303.4KB | |
| Mobile_small.stl | 294.2KB | |
| Token_1.stl | 3.2KB | |
| Token_10.stl | 2.8KB | |
| Token_2.stl | 4.0KB | |
| Token_3.stl | 13.2KB | |
| Token_4.stl | 3.2KB | |
| Token_5.stl | 3.0KB | |
| Token_6.stl | 13.9KB | |
| Token_7.stl | 3.6KB | |
| Token_8.stl | 14.7KB | |
| Token_9.stl | 3.2KB |
