Spinning Hearts Hanging Ornament 3D Printer Model
The file 'Spinning Hearts Hanging Ornament 3D Printer Model' is (3mf,stl) file type, size is 2.2MB.
The file 'Spinning Hearts Hanging Ornament 3D Printer Model' is (3mf,stl) file type, size is 2.2MB.
This is a great little Valentine's gift or ornament you can give to your loved ones. I designed this in Microsoft 3D Builder using one of the built-in heart models to start with.
I did include the 3MF file in case you wanted to fiddle with it.
The hearts all rotate around the center bar. You may need to be careful getting it off the bed if it is stuck too hard.
This is a smaller version, but I did scale up the STL to about 8.5mm thick with uniform scaling in Cura prior to slicing it. This ends up being about 105mm wide if you scale it up to almost 8.5mm thick. I left the model at the size it is because print-in-place tends to scale up much better than scaling down. :)
| SpinningHearts_v3.3mf | 1.3MB | |
| SpinningHearts_v3.stl | 2.0MB |
