Spinning Dice With 5x3mm Magnets And Improved “Dice” From “Byseven” 3D Printer Model
The file 'Spinning Dice With 5x3mm Magnets And Improved “Dice” From “Byseven” 3D Printer Model' is (stl) file type, size is 245.8KB.
The file 'Spinning Dice With 5x3mm Magnets And Improved “Dice” From “Byseven” 3D Printer Model' is (stl) file type, size is 245.8KB.
supports for printing the Top-Caps with the white arrows in 2 colours, with fillament change during the print, required to print the pieces upright and therefore it needed supports.
I used 3x5mm magnets instead of 2x5mm because i already had 3X5mm magnets at home.
I also used the remixed Alternative Print Setup file by "byseven" because the original "Dice" is not centered and also for easyer printing with the seperate pin you have to insert afterwards.
Printed verry small Antracite discs (Dia 2.5 x Height 1.5mm) to glue in the holes that represent the numbers.
| BASE.stl | 65.6KB | |
| Dice_with_seperate_pin.stl | 303.5KB | |
| Dot-Hole-inserts.stl | 590.7KB | |
| Pin_for_Dice.stl | 132.6KB | |
| TOP_2x.stl | 51.1KB |
