Default print is a women's size 7. Print is PLA.
Additional materials required:
- Elastic band for strap
- Foam for additional comfort on insole (optional)
Printing instructions:
- Print left and right half of shoe with dowels/holes face down on the bed with supports.
- Print the top of the shoe by rotating the sole 90 degrees and printing it on its side with supports.
Assembly Instructions:
- After the print is finished, remove all supports.
- The left and right portion of the shoe will snap together via the dowels.
- Once the two halves are connected, the dowel in the top piece will snap into the hole in the bottom.
- Pull elastic band through the cutout at the front of the shoe, and cut at an appropriate length for the band to hold your foot tightly.
- Once cut, pull the elastic band through the cutout again, and stitch (or staple or glue) the ends of the band together.
- Optional: Trace the cutout of the top piece onto a sheet of foam, cutout and use E600 to glue to the insole of the shoe.
