Connector piece to repair a broken spikeball set. The fit is not perfect and could be made slightly better, but it basically works. Install in two steps. First, apply glue to the existing broken plastic piece (black ring section). Second, use a heat gun or hair dryer to heat and soften the PLA. Then immediately press it into the broken spikeball ring section. Wait for the glue to dry and the printed part should be semi-permanently bonded to the original part.
Because this will be used outdoor, other materials (e.g. PETG) are probably better than PLA.
Use 100% infill.
| spikeball_repair_v12.stl | 187.1KB |
