SpeedyBee F405 Wing Mini Case 3D Printer Model
The file 'SpeedyBee F405 Wing Mini Case 3D Printer Model' is (stl) file type, size is 248.3KB.
The file 'SpeedyBee F405 Wing Mini Case 3D Printer Model' is (stl) file type, size is 248.3KB.
SpeedyBee F405 Wing Mini Case V1
Used here: https://www.youtube.com/watch?v=nm2EPVgsXIc
Connectors XT60 should be those that has the grey snap-on sleeve/protector. As it has a flange around, which prevents pulling the connectors out from the case.
14AWG Wire is used in this case.
The power wires are totally free of strain, therefore, absolutely minimal chance to rip off solder pads during crash.
The CUSTOM BOARD configuration is used (referring to the F405 manual)
The board is mounted from the bottom by 4pcs extra M2x8 screws that goes to the standoffs, through PDB board. Original screws are too short for this!
The Top cover mounts GPS BN-220, which is optional. (The GPS is put in the frame, which is glued to the cover around the guides)
4pcs of M3x10 screws were used to mount top cover to the base.
I used 3mil Depron, or you can use some foam, under the USB Board in its case. I skipped modelling around SMD components, it is useless, so rather use foam to let the SMDs sit there and be protected.
| BN-220_GPS_Cover.stl | 49.3KB | |
| F405_Mini_Cable_Separator.stl | 78.4KB | |
| F405_Mini_Top_Cover_w_GPS.stl | 112.2KB | |
| F405_Mini_USB_Case.stl | 71.8KB | |
| F405_Mini_V2_Case_Bottom.stl | 690.8KB |
