Motivaton:

• I need a speedpad mount that stays display inside boundary of V400 (to avoid hit the pad if it is outside pillar)

• The models that snaps into gaps dont work for me. Dont fit exactly or falls over... I find it too dangerous

• So, I grabbed Venon´s project to use as a base and remodeled from scratch, mantaining 10º inclination in front, removing middle part and keeping almost flat from V400 facade.

Hardware needed:

Justs 2 nuts and 2 bolts M4 (12-20mm is fine)

Design:

• I tried to keep usage of filament low, under 50gr, and a simple design, using chanfer instead of curves to print without support.

• Be gentil manipulating it. Because of offset in center of gravity not sturdy as center supported axis

• Check video assembly here: https://youtube.com/shorts/VTVyae9LhaY

Print settings:

• Print one support and two track insiders. Remember to rotate in slicer software to flat in the table like the pictures attached.

• No supports are needed, I design everything under 45º

• I printed in PLA with infill 30% in support and 50% in insiders. But a stronger material, like ABS, PETG probably is better.

Future plans:

Im planning doing a version that has a hinge to open like a door. But, for me, its working nice so far. Or, maybe, a sturdy version with more filament usage.

Cheers from Brazil