This is a very specific Phone Charging stand I made for my 2014 Motorola Nexus 6, the guts of a cheap Chinese Qi charger and a car window cell phone mount arm.
I took the guts out of a cheap Chinese Qi charger, put some electrical tape on the back of the electronics board and then folded it over super-glued it to the back of the Qi charging plate.
I then designed this phone holder to fit that Qi charger guts and my Nexus 6 along with holes to mount it onto a standard Car Window phone holder arm.
The Qi charger guts slide in from the top with the mini-USB connected at the bottom. You then plug in the power cord from underneath. Its a little tight getting my chubby fingers in there, but doable.
All this because I have a very small desk and nowhere to lay the charger down. So now I have it mounted to the side of my desk, out of the way, but still easily accessible. I made it extra thick and tough because it's hanging a $600 phone off the side of my desk!
I AM NOT RESPONSIBLE for any damage occurring to your phone, floor, or dog lying under it (or anything else) should you build this and it fails for whatever reason. Nor am I responsible for anything else that goes bad in your life...
Maybe you have a similar situation, or this will inspire you to make something like it...