Sovol SV08 ToolHead Cover (with LED) 3D Printer Model
The file 'Sovol SV08 ToolHead Cover (with LED) 3D Printer Model' is (stl) file type, size is 1.6MB.
The file 'Sovol SV08 ToolHead Cover (with LED) 3D Printer Model' is (stl) file type, size is 1.6MB.
TO DO
-Check speed/acceleration vs stock (input shaper tuning)
-Check cooling/bridging performance vs stock
Sovol SV08 toolhead cover with LED
Print with heat resistant filament.
The cover is designed to reuse the original Sovol blower fan, but you must REMOVE the front snapping part from the original fan housing.
fan_side.stl is glued to the original fan casing
template.stl is only there to help hold and position the part fan_side.stl easily while the glue dries (TEMPORARILY)
Glue is also used to hold the 4 magnets.
LED/UART Pinout
UART
1234
PIN1 LED GND
PIN2 NOT USED (I removed the wire from connector)
PIN3 LED Data
PIN4 LED +5V
***ADD those lines to printer.cfg
[neopixel thenameyouwant]
pin: extra_mcu:PA10
chain_count: 1
color_order: GRB
;You can tweak RGB LED startup color here
initial_RED: 1
initial_GREEN: 1
initial_BLUE: 0.5
/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
2x 25mm M3 bolts with nuts and washer
1x 5V WS2812b pixel single LED round pcb
https://www.aliexpress.com/item/33044419481.html
1x mini micro JST 1.25mm 4pin female connector
https://www.aliexpress.com/item/1005001535723660.html
4x 4x3mm magnet (you can reuse those from the original cover without breaking it apart if you're delicate enough)
https://www.aliexpress.com/item/1005001827614257.html
////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
Remixed extruder_side_w_fix.stl from DrewDeeDoo design
https://www.printables.com/model/1020013-sv08-fix
| extruder_side_w_fix.stl | 590.5KB | |
| fan_side.stl | 105.9KB | |
| optional_stripes.stl | 22.9KB | |
| template.stl | 325.2KB | |
| toolhead_cover.stl | 3.3MB |
