Sovol Print Bed Spacers 3D Printer Model
The file 'Sovol Print Bed Spacers 3D Printer Model' is (stl) file type, size is 8.0KB.
The file 'Sovol Print Bed Spacers 3D Printer Model' is (stl) file type, size is 8.0KB.
Update: I can verify that these fit SV01, SV03, and SV04 printers. I do not have the ability to test them on SV02, but they likely fit that as well.
Original description:
I found that my Sovol SV01's bed sat just a bit low, making it so that the springs often had to be set close to their maximum expansion (I had switched to the silicone spring replacements). These spacers are to fix that issue. They add 5mm height to the print bed, allowing you to tighten the leveling wheels a lot more the achieve the same height you would have before at a higher expansion.
To use this, print 3 "large" spacers and one "small" spacer. I advise printing at 100% infill. They should work with either the default springs or the silicone springs. If using the silicone, be sure the end with the larger hole goes up (as pictured in the photos). Otherwise, you might break the spacers when you tighten the leveling wheels down.
| Spacer_large.stl | 21.2KB | |
| Spacer_small.stl | 21.2KB |
