Sota Whip Plug 3D Printer Model
The file 'Sota Whip Plug 3D Printer Model' is (scad,stl) file type, size is 82.9KB.
The file 'Sota Whip Plug 3D Printer Model' is (scad,stl) file type, size is 82.9KB.
Tapered plug for holding 5.6m x16mm OD telescopic whip inside Aliexpress SOTA-pole (Perch Pole)
Replaces 6th section onwards, with a telescopic whip, which fits inside the SOTA pole.
Adds 2.7m to whip.
Final length is 7.8m
Total weight 510g
Has a matching guy ring that fits inside too.
It is intended that this will be seated down in the tube i.e 100mm, and the whip will bear against the fibreglass tube at the top,
so the plastic is not being bent by the whip bolt.
You should guy at the top of the 1st section of the whip, rather than the fibreglass tube. The guy ring is 15mm ID to go over the 2nd whip section to do this.
I also glue a fine ring of kevlar thread around the end of the fibreglass tube, to strengthen against splitting
| SotaPoleWhipAdaptor1.scad | 2.6KB | |
| SotaPoleWhipAdaptor1.stl | 177.8KB | |
| SotaPoleWhipGuyRing1.scad | 1.4KB | |
| SotaPoleWhipGuyRing1.stl | 127.6KB |
