Sorting Boxes For LiPo Batteries In Ammo Cans 3D Printer Model
The file 'Sorting Boxes For LiPo Batteries In Ammo Cans 3D Printer Model' is (f3z,stl) file type, size is 2.7MB.
The file 'Sorting Boxes For LiPo Batteries In Ammo Cans 3D Printer Model' is (f3z,stl) file type, size is 2.7MB.
For safe storage of LiPo Batteries I use used ammunition ammos which are available e.g. on ebay at low cost.
Important:
The ammo cans are sealed waterproof.
Cut out a small piece of the seal for possible exhaust in case of a thermal runaway!
To tidy up the batteries inside the ammo I created some sorting boxes.
They fit into ammo cans with Size approx. 33 x 19 x 23 cm (50 cal)
The silde-in Covers contain some Icons for the charging status:
Orientation of the Batteries inside the boxes shall show their status:
Using Cover_H:
If your printer can print multi colours you can used a different colour for the Icons.
But since the Icons are lofty this is not needed.
| LiPo-Boxes.f3z | 2.3MB | |
| LiPo-Box_2x.stl | 303.0KB | |
| LiPo-Box_4x.stl | 307.5KB | |
| LiPo-Box_6x.stl | 311.8KB | |
| LiPo-Box_Cover_H.stl | 26.1KB | |
| LiPo-Box_Cover_Q.stl | 26.1KB | |
| LiPo-Box_Cover_V.stl | 26.1KB | |
| LiPo-Box_low_6x.stl | 314.5KB |
