This is a conversion kit to turn WFC Siege Chromia into Solus Prime. It includes files to make a hammer, shoulder pads and the front skirt.

How to make hammer
1.) Print (1) hammer head 1 & 2.
2.) Print (2) of the handle
3.) Print (1) pommel
4.) Peg a handle into hammer head 2 so the notch goes in the slot.
5.) Peg hammer 1 & 2 together
6.) Peg the second handle into the first
7.) Peg the pommel on the bottom of the handle.

Note that hammer heads can also be used as a gun and is blast effect compatible.

How to make the skirt. This requires glue and patience. Please refer to the pictures for placement of hinges.
1.) Print (1) of the skirt top, middle and bottom.
2.) Print (4) of the skirt joining hinge and assemble them with a piece of 1.75 filament. If you leave the filament 1-2mm longer you can melt the ends with the hot end and flatten so it forms a head on each side.
3.) Glue hinges to the top, middle and bottom centered where they fit against one another. They top, middle and bottom pieces should fit exact into one another.
4.) Print (2) skirt attachment hinges and repeat what you did on the previous hinges with filament.
5.) Glue one side of the skirt attachment hinge to the skirt top piece.
6.) Glue the other side of the skirt attachment hinge to chromia's crotch. Make sure to remove the detachable crotch piece that pops off when you rotate her before doing this.
7.) If hinges are not stiff enough you can use floor polish or nail polish to tighten the joints.

Shoulder pads just slide onto chromia's shoulders. they do kind of peg in place but can easily pop off. For a more permanent fixture a small dab of glue can be used.

Pop off the rear wheels and replace with the turbines. Note that the turbine is meant to be facing upward with the shaft down towards the plastic.

For alt mode transform as you would chromia but rotate the back half so its upside down and flip out the sides. With the hammer disassembled peg the hammer heads into the sides of the leg kibble. The handles are placed in her hands with the notches facing down and pegging them into the pommel using the tabs.

**Do this at your own risk. I am not responsible for damage to your figure or any injury from attempting this. This is not necessary and only adds options to the figure
For super hammer mode and anvil you will need to pop the pin in the back that holds the canopy of the vehicle. The rear sides just pop off and are only held on by friction. These peg into the canopy as shown in the picture. The leg kibble will require removing the pin (suggested using a soldiering iron).

For the best look print at the highest quality. sanding or filing may be required depending on your settings.