Ready for a in depth project?
The engine runs at a high rate of speed, but gets to hot for PLA after 2-5 min. Id like to see someone make this made in ABS or a better power/solenoid setup for better heat tolerances.
to make this engine you must know how to use and program an Arduino. u must know the basics of electronics.
| ArmElbo.skp | 45.9KB | |
| ArmElbo.stl | 160.5KB | |
| baceMainSupport.skp | 94.3KB | |
| baceMainSupport.stl | 62.7KB | |
| camSpacer12mm.skp | 21.8KB | |
| camSpacer12mm.stl | 34.9KB | |
| crankShaf.stl | 199.4KB | |
| crankShaft.skp | 59.4KB | |
| engineBace.skp | 38.9KB | |
| engineBace.stl | 115.7KB | |
| engineBlock.skp | 60.0KB | |
| engineBlock.stl | 173.3KB | |
| engineBlockShaft.skp | 14.0KB | |
| engineBlockShaft.stl | 24.9KB | |
| lockJoint.skp | 34.9KB | |
| lockJoint.stl | 72.0KB | |
| piston.skp | 28.9KB | |
| piston.stl | 97.0KB | |
| positionDisk.skp | 28.9KB | |
| positionDisk.stl | 67.0KB | |
| Sensor.skp | 74.7KB | |
| Sensor.stl | 271.5KB | |
| SnapRings10MM.stl | 34.3KB | |
| solinoid.skp | 57.1KB | |
| solinoid.stl | 177.9KB | |
| upperBacePlate.skp | 169.6KB | |
| upperBacePlate.stl | 413.1KB |
