A model of a standard sodastream cap. It is easy to print. I havent use supports, but if you dont mind taking them off, print quality could be beteer with them. There are two ways to print this model. One is to print out the whole complete Cap in one material, the other one is to print outside cap in some hard material and the inner rubber with some flex filament. Cap with rubber piece is better seals the bottle. Rubber piece should partly fit to the cap. After you just place it in, screw the cap on bottle and it should fit the sealing on place. If it doesent help, just use a bit of force :)
If you have any questions or problems, you can leave a comment or message me. If you like this model you can leave a feedback :)
| Cap.stl | 260.4KB | |
| Complete_Cap.stl | 279.6KB | |
| Rubber_Sealing.stl | 55.6KB |
