Socket Extension And Ratchet Organizer 3D Printer Model
The file 'Socket Extension And Ratchet Organizer 3D Printer Model' is (stl) file type, size is 18.6KB.
The file 'Socket Extension And Ratchet Organizer 3D Printer Model' is (stl) file type, size is 18.6KB.
This little organizer is designed interlock together to hold your socket extensions and ratchets in place in your toolbox and keep them from rolling around. I'm currently using them for 1/4", 3/8", and 1/2" extensions (both chrome and impact) and the same for ratchets. You could, of course, use them for whatever it is you want to organize that fit in the channel.
The hole in the bottom is designed to fit a 12mm x 3mm magnet (~1/2"). I've been using these ones from Home Depot - depending on your print they may require a bit of force to fit but that's intentional so they stay in place. If it feels like you're going to break it trying to press the magnet into the organizer, flip it over and press the organizer down onto the magnet on a table or hard surface. Should snap right in.
Aside from holding the organizer in place in your toolbox drawer (even through a drawer liner), these magnets are also strong enough to hold the extensions and ratchets in place.
Different sized spacers are also included. I've had to use one or two here and there to account for large ratchet heads or other issues with spacing - but allowing me to keep a chain of organizers intact.
| ExtensionOrganizer_v9.stl | 50.0KB | |
| ExtensionSpacer-12mm_v4.stl | 16.7KB | |
| ExtensionSpacer-16mm_v4.stl | 16.7KB | |
| ExtensionSpacer-20mm_v4.stl | 16.7KB |
