This is an updated version of the frame I designed in my video here: https://www.youtube.com/watch?v=wO_aDar1q0Q
Though not very strong, this frame is perfectly 3d printable.
I have not tested the new frame, let me know how it goes! I will make changes based on suggestions.
Updates include:
Shorter arms (still fits 22xx size motors and 5" props)
Now your vtx can be mounted vertically with the coax mounted up through the rear hole with a washer, or use a pigtail.
zip tie holes to secure battery leads from the PDB
Holes for camera mount.
Holes to put a zip tie to hold your receiver antennas
Warning: I can't figure out why, but the XT60 hole exports funny. You will have to file the bottom edge flat.
| SNRS_5_bottom_plate_4mm.stl | 1.6MB | |
| SNRS_5_top_plate_2mm.stl | 398.8KB | |
| SNRS_5_top_plate_3mm.stl | 515.6KB |
