Log sleigh for RC snowmobile
This is scaled to fit the 1/6 scale Yamaha or Polaris Rush
Yamaha 1/6 : https://www.thingiverse.com/thing:3432547
UPDATE I just uploaded the hitch parts to mount on your non-hitch yamaha extended tunnel using a M2.5x8 screw and a piece of 1.75mm filament for the little "tongue".
I just finished printing this and i think i went a little big on the scale, it could be 10% smaller to be honest but i'll try it outside when it's not -28c like today O.o
Requires:
You need to tie the chains in a "X" like in the pictures.
Adjust the chain length to match your log length.
PS.: Leave the Upper Frame to Frame screw a bit loose, the upper frame should pivot freely.
Everything should be pretty easy to print without supports.
Print the skis on their side, the posts on their flat spot, the frame on its side and the upper frame with the bottom down. The rear ski tie can be printed horizontal for best strenght.
| Frame.stl | 79.8KB | |
| Hitch.stl | 50.9KB | |
| Post.stl | 94.9KB | |
| promod_hitch.stl | 122.7KB | |
| Promod_Hitch_Hand.stl | 116.2KB | |
| Promod_Hitch_Mount.stl | 186.2KB | |
| Rear_Ski_Tie.stl | 169.4KB | |
| Ski.stl | 47.1KB | |
| Upper_Frame.stl | 58.9KB |
