Snowball Making Terminal Device 3D Printer Model
The file 'Snowball Making Terminal Device 3D Printer Model' is (stl) file type, size is 13.3MB.
The file 'Snowball Making Terminal Device 3D Printer Model' is (stl) file type, size is 13.3MB.
Snowball making device for young padawans with upper limb prosthetic with 1/2-20 thread adapter.
Snowball diameter = 60mm( slightly smaller than tennis ball)
total lenght of device = 144mm
video of device in use: https://youtu.be/3F43lDbf_rc
note: To make snowball, snow has to be tightly pressed. Just closing top part over the other will not result in a firm ball. Use other hand to press both sides together and then remove the ball.
| anchor.stl | 19.0KB | |
| bottom_adorned.stl | 8.3MB | |
| Bottom_cup_blank.stl | 481.8KB | |
| PIN.stl | 32.9KB | |
| proximal_adapter.stl | 112.0KB | |
| Top_1_adorned.stl | 11.7MB | |
| Top_2_adorned.stl | 11.6MB | |
| Top_cup_blank.stl | 2.6MB |
