A set of cable clips to improve cable management on Snapmaker 2.0 printers. All the clips are designed to be fastened with M4 Hex Socket Head Screws, the standard fastener on these machines.
H_Clip is designed to clip the tool-head cable along the top of the horizontal actuator beam. Usually two will be required.
V_Clip is designed to clip one or two cables running up the vertical actuators. Up to four of these will be useful to route cables into the controller.
Top_Clip screws to the top of the vertical actuators and supports cables exiting at the top of the enclosure. One or two may be used depending on cabling.
X_End is a two-part cap for the ends of the horizontal actuator beam. It takes up slack in the motor cable and rotates its exit for a cleaner cable run and also provides a mounting for an LED spotlight to illuminate the extruder heads. One pair is required, or two if spotlights are fitted on both ends of the beam. This assembly is carefully designed with stand-offs to avoid blocking airflow round the motor.
| H_Clip.stl | 49.1KB | |
| Top_Clip.stl | 163.9KB | |
| V_Clip.stl | 94.8KB | |
| X_End_Inner.stl | 128.4KB | |
| X_End_Outer.stl | 351.3KB |
